-
Ok, here is the ifconfig:
eth0 Link encap:Ethernet HWaddr 08:00:27:96:9c:03
inet addr:10.0.2.15 Bcast:10.0.2.255 Mask:255.255.255.0
inet6 addr: fe80::a00:27ff:fe96:9c03/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:17597 errors:0 dropped:0 overruns:0 frame:0
TX packets:12245 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:14359442 (14.3 MB) TX bytes:1381566 (1.3 MB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:52 errors:0 dropped:0 overruns:0 frame:0
TX packets:52 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:4070 (4.0 KB) TX bytes:4070 (4.0 KB)
and iptables - save does nothing.
Jonny
-
It's "iptables-save" not "iptables - save". The latter should return "bad argument". Look at my post again, and post output from both VMs, identifying each. If you want to.
-
No, nothing at all just gives the prompt again as if it has done something but doesn´t want to tell me what.
