-
wireless network issue
I just received nearly 200mbs of updates - and now I can't connect to my wireless network.
Wired works fine:
Code:
[root@vaio ~]# dhcpcd -d eth0
dhcpcd: MAC address = macaddress
dhcpcd: your IP address = ipaddress
[root@vaio ~]#
But my wireless doesn't even try to connect:
Code:
[root@vaio ~]# dhcpcd -d eth1
[root@vaio ~]#
Is anyone else experiencing the same problem?
My rc.conf is fine:
Code:
lo="lo 127.0.0.1"
eth0="dhcp"
eth1="dhcp"
INTERFACES=(lo eth0 eth1)
And my /etc/conf.d/wireless is fine:
Code:
#BORO WIRELESS
wlan_eth1="eth1 essid marsHsys3"
#wlan_eth1="eth1 essid marsHsys3 key 12345678"
#wlan_eth1="eth1 essid marsHsys3 key s:wirelesspassword"
Anyone have any ideas as to what the problem could be? Did the new patches remove the conf.d/wireless option, do I have to do wireless another way? If so, how?
-
I just noticed something strange:
Code:
[root@vaio ~]# iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
eth1 no wireless extensions.
Warning: Driver for device eth2 has been compiled with version 20
of Wireless Extension, while this program supports up to version 19.
Some things may be broken...
eth2 IEEE 802.11b ESSID:"marsHsys3" Nickname:"HERMES I"
Mode:Managed Frequency:2.412 GHz Access Point: 00:13:10:6B:F0:B7
Bit Rate:11 Mb/s Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=45/92 Signal level=-42 dBm Noise level=-87 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:1
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
sit0 no wireless extensions.
[root@vaio ~]#
Weird thing #1: It's showing it under eth2 now. How and why?! It's always been eth1...
Weird thing #2: What's that error trying to say?
************************************************** *************************************
Well I went thru added eth2 everywhere eth1 used to be - and ran
and sure enough it works.
Sigh - I have absolutely no idea what happend or why.
I'll just keep checking iwconfig and see if maybe the error message thing for eth2 goes away. One of the updates did something. Oh well, I have wireless again!
-
looks like your driver version has surpassed the package version of wireless tools. Probably nothing to worry about you'll get a new update for wireless tools when they catch up. Though, I don't have any idea why your interface changed to eth2.
-
Yea I'll keep an eye out for updates. At least it still works fine.
Just out of curiosity, whats sit0 stand for?
This laptop has a built in ethernet card, built in wireless b & a slot for a wireless adapter, so I see where the eth0/1/2 come from. But sit0...?
************************************************** *************************************
Just got a wireless tools update via -Syu and now the error is gone. Wow that was quick =)
