DSL problems on Etch

[Burble]

Hello. Just got my new DSL router from T-com and a user name and password. When I ran PPPoE-config, it refused to acknowledge there was anything on eth0. Then I tried roaring penguin's configuration tool, and everything seemed OK until I tried to connect with pppoe-start. Nothing happened, and the connection attempt timed out. The hardvare seems OK, since the router detected the ethernet port, and the ADSL light was on.

Thanks in advance.

[boggy]

Try using ifconfig and plumb it.

[Burble]

Ok, here it goes....

eth0 Link encap:Ethernet HWaddr 00:118:E1:11:AE
inet6 addr: fe80::211:d8ff:fee1:11ae/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:9 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:684 (684.0 b)
Interrupt:193

eth1 Link encap:Ethernet HWaddr 00:0E:0C:6F:A6:2E
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:8 errors:0 dropped:0 overruns:0 frame:0
TX packets:8 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:560 (560.0 b) TX bytes:560 (560.0 b)