Problem found after installation

[satimis]

Hi folks,

OpenBSD 4.1 amd64
Install on CD

Just finished installing OBSD. On reboot OBSD started but encountering following problems;


1)
Unable to connect Internet

# ping -c3 yahoo.com
hanging here

# ping -c3 192.168.0.10

....
3 packets transmitted, 0 packets received, 100.0% packet loss

192.168.0.10 is the IP of this box on the router.

# ifconfig

lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 33192
	groups: lo
	inet 127.0.0.1 netmask 0xff000000
	inet6 ::1 prefixlen 128
	inet6 fe80::1%lo0 prefixlen 64 scopeid 0x4
nfe0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
	lladdr 00:0e:a6:f9:a3:5b
	groups: egress
	media: Ethernet autoselect (100baseTX full-duplex)
	status: active
	inet 192.168.1.10 netmask 0xffffff00 broadcast 192.168.1.255
	inet6 fe80::20e:a6ff:fef9:a35b%nfe0 prefixlen 64 scopeid 0x1
pflog0: flags=0<> mtu 33192
enc0: flags=0<> mtu 1536

2)
Problem on obtaining CVSUP, unable to find "cvsup-16.1hp0-no_x11.tgz" on;
ftp://ftp.openbsd.org/pub/OpenBSD/4.1/packages/amd64


Pls help. TIA


B.R.
satimis

[onlinebacon]

can you ping your router?

if you don't have a connection to the internet you wouldn't be able to cvsup so no point in trying that like you did

[satimis]

Hi onlinebacon,

I solved my problem 1). The solution is quite simple and straight forward.

Just ran;
# dhclient nfe0

then
# ping -c3 yahoo.com

.....
3 packet transmitted, 3 packets received, 0.0% packet loss

# ping -c3 google.com

.....
3 packet transmitted, 3 packets received, 0.0% packet loss

Internet connected. That is all.

I found "nfe0" by running;
# ifconfig

....
nfe0: flags=8843......
....

My remaining problem is where to get "cvsup-16.1hp0-no_x11.tgz" for amd64.

Not on
ftp://ftp.openbsd.org/pub/OpenBSD/4.1/packages/amd64


B.R.
satimis

[nalg0rath]

My remaining problem is where to get "cvsup-16.1hp0-no_x11.tgz" for amd64.

Not on
ftp://ftp.openbsd.org/pub/OpenBSD/4.1/packages/amd64

The problem probably is that Modula-3 is not supported on all platforms, and that is the language cvsup is written in. They only have packages for the supported platforms.

Fortunatly there is a C-port of cvsup, csup. You should be able to find the csup-20060318.tgz package on your mirror.