tvtime wont work on my saa7130 tvtuner

[vikrant_me]

It gives the following error:

[root@localhost doc]# tvtime
Running tvtime 1.0.1.
Reading configuration from /etc/tvtime/tvtime.xml
Reading configuration from /root/.tvtime/tvtime.xml
Xlib: extension "XVideo" missing on display ":0.0".
xvoutput: XVIDEO extension not found: X too old? didn't load extmod?

lspci -vv gives me :

04:07.0 Multimedia controller: Philips Semiconductors SAA7130 Video Broadcast Decoder (rev 01)
Subsystem: Philips Semiconductors Unknown device 0000
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (3750ns min, 9500ns max)
Interrupt: pin A routed to IRQ 11
Region 0: Memory at febffc00 (32-bit, non-prefetchable) [size=1K]
Capabilities: [40] Power Management version 1
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-

Its however not listed under dmesg!

What could i try here ? im pretty new to linux

[vikrant_me]

ok i downloaded the driver for my card the readme says the following:

Build
=====

Pick up videodev + v4l2 patches from http://bytesex.org/patches/.
Configure, build, install + boot the new kernel. You'll need at least
these config options:

CONFIG_I2C=m
CONFIG_VIDEO_DEV=m

Type "make" to build the driver now. "make install" installs the
driver. "modprobe saa7134" should load it. Depending on the card you
might have to pass card=<nr> as insmod option, check CARDLIST for
valid choices.

I am lost here, could someone help me out with this?