Xserver doesn't start ( frezzes all)
Hi people I've been struggling with it for a couple of days. I just installed gentoo from the LiveCD in a DELL XPS M1330 Laptop. It uses a Intel Core Duo 2 with an Intel Mobile(R) 965 Express family chipset. I've followd the manual of the Xserver installation from the gentoo site , when I try to test it wih X -configure or startx . The screen goes black, keyboard and mouse unresponsive. I must remove the battery to restart it :dazed:. This is the Xorg.0.log file : ( I couldn't paste the whole file these are just the warnings and errors)
X.Org X Server 1.7.6
Release Date: 2010-03-17
X Protocol Version 11, Revision 0
Build Operating System: Linux 2.6.32-gentoo-r7 i686
Current Operating System: Linux dhcppc0 2.6.32-gentoo-r7 #1 SMP Sat Apr 10 22:41:45 Local time zone must be set--see zic i686
Kernel command line: BOOT_IMAGE=gentoo ro root=100 init=/linuxrc ramdisk=8192 real_root=/dev/sda6
Build Date: 10 April 2010 08:13:42PM
Current version of pixman: 0.17.2
(II) LoadModule: "fbdev"
(WW) Warning, couldn't open module fbdev
(II) UnloadModule: "fbdev"
(EE) Failed to load module "fbdev" (module does not exist, 0)
(WW) Falling back to old probe method for vesa
drmOpenDevice: node name is /dev/dri/card0
[drm] failed to load kernel module "i915"
(EE) intel(0): [drm] Failed to open DRM device for : No such file or directory
(EE) intel(0): Failed to become DRM master.
(II) intel(0): Integrated Graphics Chipset: Intel(R) 965GM
(--) intel(0): Chipset: "965GM"
(--) intel(0): Linear framebuffer at 0xE0000000
(--) intel(0): IO registers at addr 0xF6E00000 size 1048576
(WW) intel(0): libpciaccess reported 0 rom size, guessing 64kB
(II) intel(0): the SDVO device with slave addr 70 is found on DVO 1 port
(II) intel(0): 2 display pipes available.
(II) Loading sub module "ddc"
(II) LoadModule: "ddc"
(II) Module "ddc" already built-in
(II) Loading sub module "i2c"
(II) LoadModule: "i2c"
(II) Module "i2c" already built-in
(II) intel(0): Output VGA has no monitor section
(II) intel(0): Output LVDS has no monitor section
(II) intel(0): I2C bus "LVDSDDC_C" initialized.
(II) intel(0): Attempting to determine panel fixed mode.
(II) intel(0): I2C device "LVDSDDC_C:ddc2" registered at address 0xA0.
I'm lost I don't know where to start. Thanks for the help and sorry for the long paste of the log file .