Epson Perfection v100 can see but cannot scan
Ok I'm missing something but cannot figure out what.
I recently got a an Epson Perfection V100 after checking and finding it had good Linux support. I first tried it on an FC5 box. I installed the latest Sane backends. Then I tried it on an FC6 box with same lack of success.
T: Bus=03 Lev=01 Prnt=01 Port=03 Cnt=01 Dev#= 2 Spd=480 MxCh= 0
D: Ver= 2.00 Cls=ff(vend.) Sub=ff Prot=ff MxPS=64 #Cfgs= 1
P: Vendor=04b8 ProdID=012d Rev= 1.00
S: Product=EPSON Scanner
C:* #Ifs= 1 Cfg#= 1 Atr=c0 MxPwr= 2mA
I: If#= 0 Alt= 0 #EPs= 2 Cls=ff(vend.) Sub=ff Prot=ff Driver=(none)
E: Ad=81(I) Atr=02(Bulk) MxPS= 512 Ivl=0ms
E: Ad=02(O) Atr=02(Bulk) MxPS= 512 Ivl=31875us
The USB bus sees it.
[root@gandalf hold]# sane-find-scanner
# sane-find-scanner will now attempt to detect your scanner. If the
# result is different from what you expected, first make sure your
# scanner is powered up and properly connected to your computer.
# No SCSI scanners found. If you expected something different, make sure that
# you have loaded a kernel SCSI driver for your SCSI adapter.
# Also you need support for SCSI Generic (sg) in your operating system.
# If using Linux, try "modprobe sg".
found USB scanner (vendor=0x04b8 [EPSON], product=0x012d [EPSON Scanner]) at libusb:003:002
# Your USB scanner was (probably) detected. It may or may not be supported by
# SANE. Try scanimage -L and read the backend's manpage.
# Not checking for parallel port scanners.
Sane can see it, tell me it's there.
I installed Iscan, and any attempt to scan comes up with cannot send command to scanner both as root or as normal user.
I edited /ect/sand.d/ epson.conf and ekowa.conf to remark out SCSI scanning.
I tried adding this line to the epson.conf file with no success
which is what it shows up as in /dev
Xsane just tells me it no devices availible both as root or normal user. This is both as the Gimp plugin or running Xsane directly from the command line.
I tried to force it on the FC5 box using the usb <product ID> <device ID> but could never figure out how to get the device ID. I tried using what USB bus it was on but that gave me same result as all other efforts.
I know I'm overlooking something but cannot figure out what I'm over looking.