Printable View
Hi everybody,
Ever since I moved to a 2.6 kernel (and therefore udev), I haven't been able to access my USB flash drive. It used to be /dev/sda, and my harddrive was /dev/hda. Now my harddrive is /dev/sda, and I don't know where to look for it. I've gone over /sys/bus/usb, but under devices there, there's 5 usb devices. How do I know which one is the right one, and where is the device to mount?
Thanks!
Try /dev/sda1 when your usb_storage module is loaded (and the necessary scsi support). This happens (dmesg) when I plugin an usbstick:
Code:usb 3-2: new high speed USB device using ehci_hcd and address 3
SCSI subsystem initialized
Initializing USB Mass Storage driver...
scsi0 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 3
usb-storage: waiting for device to settle before scanning
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
Vendor: Kingston Model: DataTraveler 2.0 Rev: 1.00
Type: Direct-Access ANSI SCSI revision: 02
usb-storage: device scan complete
SCSI device sda: 2002944 512-byte hdwr sectors (1026 MB)
sda: Write Protect is off
sda: Mode Sense: 0b 00 00 08
sda: assuming drive cache: write through
SCSI device sda: 2002944 512-byte hdwr sectors (1026 MB)
sda: Write Protect is off
sda: Mode Sense: 0b 00 00 08
sda: assuming drive cache: write through
sda: sda1
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 0
I don't think that'll work, considering that my harddrive (an SATA) is at /dev/sda.
If /dev/sda stands for your hard drive then, usb flash drive should be accessible by /dev/sdb or /dev/sdc ! Try it and lemme know if this works.
No go; none of them are valid block devices.