FC4 installation problem!!!!!!!!

HI there,

I am a noob in linux. I have problems in installing linux FC4. When I boot from the FC4 disk 1 I get options that say press enter to install linux in GUI . So when I press enter installation starts but nothing happens after that.

Then I tried with the code boot: linux noprobe
Then installation started and I got the gui . After installation was completed
I rebooted the PC and selected FC4 from the boot menu. Then it did not boot!!!

My pc is of following config.

Asrock M/B(Intel 865G chip buit in sound/Graphic/lan)

Intel Celeron D (2.26Ghz)

Nvidia Geforce FX 5200

512 MB DDR 400 Ram

Rahul

on GRUB screen, select Fedora's title and press 'e' and add '3' at the end of kernel line. it will drop you at command line login prompt.

login as root and type 'startx'.
post error message if any.




casper

Hi Casper,
I get these lines if I press e:

kernel /boot/vmlinuz-2.6.11-1.1369_FC4 ro root=LABLE=/1 rhgb quiet
initrb /bbot/initrd-2.6.11-1.1369_FC4.img

I'he tried these:

kernel /boot/vmlinuz-2.6.11-1.1369_FC4 ro root=LABLE=/1 rhgb quiet3
initrb /bbot/initrd-2.6.11-1.1369_FC4.img

kernel /boot/vmlinuz-2.6.11-1.1369_FC4 ro root=LABLE=/1 rhgb quiet 3
initrb /bbot/initrd-2.6.11-1.1369_FC4.img

And both times same things happend.

it somewhat like this::
Call trace:
[<c0128c6d>] __reuest_region+0x54/ 0x758
...................
..................
stuff like that
and then

Code : 9c 3c c0 89 d0 ......
....................................
/etc/rc.d/rc.sysinit:line 165 :937 Segmetation Fault modprobe $1>/dev/null 2>&1
network

thx
Rahul

re-install...... coz of 'noprobe' FC got installed but its not able to configure hardware now.
at boot: prompt, try these options......

Code:

---

linux ide=nodma
linux acpi=off
linux i8042.nomux
linux acpi=off apm=off
linux nofb

---

casper