Motor is running, but not off the ground
I have a post in the debian newsgroups section too, but you guys have been more helpful in the past, so I humbly ask for assistance again.
My NIC card:
U.S. Robotics 10/100 PCI NIC TX
Model # is USR7900
Just installed Debian 3.0r Woody, and cannot get the NIC to work. It does not show up on the driver list that I can install from the install disks, and modprobe tulip didn't do squat.
It worked fine under SuSE 8.2 so I figured this wouldn't be a problem. I think it is a driver issue (actually a LACK of a driver), but I cannot seem to find a driver for this. There must be one for linux, since SuSE ran it without a hiccup.
When I run ifconfig, it just shows up lo (which I hate to admit ignorance, but I am not sure what lo is ... I am used to the network interfaces as eth0, eth1 etc).
Any ideas where I might be able to find a driver, or any other way to get the NIC working? Hate to buy a new one, as this one works fine otherwise. Thanks in advance.