Printable View
Hello,
I am trying to install Linux on a hard drive that has Windows already. I partitioned it: first logical partition - win, then - linux. While installing (Red Hat) I get he following message: Boot partition may not meet booting constraints for your architecture.
After installlation I am never able to start LILO. Its always Windows...
Any ideas...?
tnanx
Does your BIOS support LBA on your hard drive?
Did you format the partition that you wanted to install Linux to? If so, what format?
What's LBA?
I formatted partition while installing Linux - typical (ext3 for /, and swap)
thanx
Everything you wanted to know about LBA, but were afraid to ask. ;)
Make sure that your BIOS supports LBA and you have it turned on for your drive.
ok, my BIOS does not support LBA. Is there anything else I can do?
thnx
hay guys,
i have one query,
is it possible to install dual mode in a single system.note;both are linux.
if it is possible try to send details.
Thanks & Regards
babu k
babuk@aventail.com
hi babuk !!
its possible and i have four OS in the single machine... FC5, Kubuntu, SuSe and Xp...Quote:
Originally Posted by babuk
if you know about Dual Boot then installing other distro wont be a problem...
check these articles on Dual Boot ...
http://www.devhood.com/tutorials/tut...utorial_id=405
http://www.howtoforge.com/windows_linux_dual_boot
<=== { casper } ===>
http://www.linux.org/docs/ldp/howto/...k-HOWTO-5.htmlQuote:
This means that a Linux kernel can only be booted when it is entirely located within the first 1024 cylinders, unless you both have a modern BIOS (a BIOS that supports the Extended INT13 functions), and a modern bootloader (a bootloader that uses these functions when available).
This problem (if it is a problem) is very easily solved: make sure that the kernel (and perhaps other files used during bootup, such as LILO map files) are located on a partition that is entirely contained in the first 1024 cylinders of a disk that the BIOS can access - probably this means the first or second disk.
Thus: create a small partition, say 10 MB large, so that there is room for a handful of kernels, making sure that it is entirely contained within the first 1024 cylinders of the first or second disk. Mount it on /boot so that LILO will put its stuff there.
Most systems from 1998 or later will have a modern BIOS.
The fdisk -l /dev/hda command should show the cylinder info
on your first hard drive. If your linux partition is above cyl 1023,
and your BIOS doesn't support extended int 13 instructions,
you'll have to use some kind of workaround like creating a small
/boot partition within those limits, booting from floppy,
or installing a second hard drive.
:cool: