Find the answer to your Linux question:
Results 1 to 3 of 3
Enjoy an ad free experience by logging in. Not a member yet? Register.
  1. #1

    board is not booting

    hi all,
    I am working on leopard board dm355,when i boot my board on minicom nothing will be displaying.I loaded uboot through hyperterminal,then it is working fine,it is loaded sucessfully.
    where is the problem?how to overcome this problem?
    please send me reply

  2. #2
    have you verified that the correct serial device and terminal settings (baud rate, parity, etc.), in minicom are correct, or at least match those used in hyperterm? you can start minicom with the -s flag to go straight to the configuration screen (from the main menu, select Serial port setup).

    are you sure that the serial device you are using in Linux (/dev/ttyS0, etc.) is otherwise working properly?

  3. #3
    thank u for your it is working fine,because its switch has some problem.

  4. $spacer_open

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts