emanjamin2002

OK, thanks.

Emmanuel

emanjamin2002

Thank you. I did the steps from the bottom of the page. No success. Still the same. It passes through the last 2 steps as mentioned earlier where it bugs. Then it goes to another line with "Eth2 detected...." and it freezes. So not sure what to do anymore or shall I try something else on the list mentioned from the Tips and tricks????
Thanks
Emmanuel

MikeTbob

You can probably get it to boot using one or two of the other boot codes,
knoppix nohwsetup
knoppix acpi=off noapic noapm
I'd try them all, one by one if I had to. But then again, I would remove hardware parts from my machine, just to see if something isn't compatible.

__________________
I do not respond to private messages asking for help.
Please keep it on the forums only.

emanjamin2002

Thank you very much for your help. I will try them. As you may have seen, I am just starting with Lunix and not a PRO and I don't really understand what you mean by "I would remove hardware parts from my machine..." which ones if I want to do that?
I will first start with what you mentioned. Thanks.
Emmanuel

elija

Before I removed hardware, I would try another distro to see if it
was a general problem or one specific to Knoppix.

It could also be a corrupted ISO image or CD.

__________________
"I complement you - your facility of understatement is exceeded only by your mastery of silence, but measuring this with the word 'shame' surpasses all your previous achievements in articulation"

The Fifth Continent

MikeTbob

Good Idea, there is also a testcd cheatcode
knoppix testcd

__________________
I do not respond to private messages asking for help.
Please keep it on the forums only.

emanjamin2002

Thanks. I already checked the ISO Image and it is fine and the codes are indentical so I think this is fine. I will start doing what Mike told me and I will let you know.
EMmanuel

emanjamin2002

Thank you. First I am going to start shortly with the list of the Tips and Tricks and I will let you know.
Emmanuel

emanjamin2002

hello,
I did the test on the CD and everything is OK. Then it continued the process to load Knoppix and bugged again at the same location.
Shall I try another Image ISO? I don't want to install it and knoppix is the only one I know that I could do. Is there another one I can do and use without installing it on my system? What do you think is the best?
thank you.
Emmanuel

emanjamin2002

I also answering Mike. I did the test on the CD and everything is fine. I asked Mike if there was another ISO Image that I can use without installing it in my system?
Thanks