so close to have my pcmcia NIC working...
I did plug a linksys pcmcia ethernet card to my laptop,
did boot linux Mandrake 7.0 -> at linux boot up, I can
see "cardmgr" has detected the Linksys Etherfast network card (with no mention of irq, nor I/O).
->/sbin/cardctl status and /sbin/cardctl ident
both detect the card:
5V 16-bit pc card
function 0: [ready],[wp]
But does not give m eany I/O and IRQ!!!!
# /sbin/cardctl ident
Product info: "Linksys", "Etherfast 10/100 Integrated PC Card (PCM100), "Ver 1.0"
manfid: 0x0149, 0xc1ab
function: 6 (network)
Is the MANFID the I/O??? What about the IRQ?
How come the IRQ and I/O are not displayed?
Actually, even with "LSPCI -V", I do not get any
entry "I/O,IRQ" for my network card!
More details that tells me that I am so close to have
the pcmcia working ->
->when I run "lsmod" , I get:
pcmcia_core (used by ds i82365)
i82365 (used by 2) ..that's the module for my nic right?
->card services are running cause
when I run " ps -ef | grep cardmgr ", I get:
root 746 1 9 19:05 /sbin/cardmgr
->In /etc/sysconfig/pcmcia, I have:
BUT IN /etc/pcmcia/config, there's no exact entry
for my nic (such as it was outputted by "/sbin/cardctl ident"). Most of them are linksys e-cards, except for
the following one:
->card "Linksys Ethernet"
version "Linksys", "Combo PCMCIA Ethernet Card (EC2T)"
Actually there's an entry that caught my attention
cause it has same "MANFID" as the "CARDCTL IDENT" outputs on my system:
->card "NE2000 Compatible Ethernet"
version "Ethernet", "Adapter"
#manfid 0x0149, 0xc1ab
(What's the point of /etc/pcmcia/config? What do I need to do here? should I rely on the ne2000 entry or should I absolutely add or rely on the linksys entries. If I should rely on the ne2000 entry, should I take out the # symbol in front of manfid 0x0149, 0xc1ab ?? ??????)
What do I need to do to complete the setup
of this NIC card (for now, ifconfig has no entry for eth0)
Really sorry for all these writings.
I just need this detected NIC to be set (using ifconfig),
but am limited by the fact there's no clue of what
I/O or IRQ goes with it.
Linux Mandrake 7.0
nic: linksys pcmcia etherfast 10/100 pc card (pcm100 v2)