How to configure a RTL8029(AS) for cable modem settings
i have some trouble with my internet connection. I'm working with a cable modem, and it means that my ethernet card must be set up in half_duplex mode 10baseT. The "module configuration" of my ethernet card in harddrake has three options, but i don't know how to fill them... DEBUG, OPTIONS and FULL_DUPLEX are the three options.
So i've tried using the commandline, but mii-tool does not work
[root@cable-62-205-116-61 felix]# mii-tool
SIOCGMIIPHY on 'eth0' failed: Operation not supported
no MII interfaces found
and i don't realy understand how to use ifcfg to do this.
So i had a "emacslook" in /etc/modules.conf, but it was the same : what should i write in there to set up my eth0 in half_duplex 10baseT.
Any help will be welcome (graphic hints, commandline tricks, emacs goodies,...)
Oh, and here is my ifconfig
[root@cable-62-205-116-61 felix]# ifconfig
eth0 Lien encap:Ethernet HWaddr 00:80:C8:DD:E5:F4
inet adr:220.127.116.11 Bcast:255.255.255.255 Masque:255.255.252.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1880716 errors:0 dropped:0 overruns:0 frame:1742
TX packets:7393 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:1000
RX bytes:121549345 (115.9 Mb) TX bytes:903971 (882.7 Kb)
Interruption:5 Adresse de base:0xd400