Mounting USB Mass Storage located on Digital Camera

[Primary Canary]

Dear Forum,
I bought a Fuji Finepix 3800 digital camera. I was doing some research via google and I found out that you can mount most digital cameras using the USB Mass Storage protocol. However, I cannot seem to figure out which device to mount. I am running Red Hat 7.3 and I think that the computer can see the camera. When I hook up the camera to the computer with the USB cable and turn the camera on, a new directory called usb-storage-0 is created in /proc/scsi. Inside this directory is a text file named 1.
the contents of the file are as follows:

Host scsi1: usb-storage
vendor: unknown
Product: USB Mass Storage
Serial Number: Y-406^^^^^021216XFPX0004032070
Protocol: 8070i
Transport: Control/Bulk/Interrupt
GUID: 04cb011a161fb10004032070
Attached: Yes

Now how do I mount this? I tried sda0-7 to no avail. Can anyone help me out? Thanks for any help.
- Primary Canary

[l_Kriss]

try dmesg | more and see if you find your camera along with the device its on

[Primary Canary]

I tried dmesg | more and this was the output:

[root@localhost root]# dmesg
ame# 215
usb-uhci.c: interrupt, status 3, frame# 1131
usb-uhci.c: interrupt, status 3, frame# 2047
usb-uhci.c: interrupt, status 3, frame# 915
usb-uhci.c: interrupt, status 3, frame# 1827
usb-uhci.c: interrupt, status 3, frame# 695
usb-uhci.c: interrupt, status 3, frame# 1611
...etc

every line contained usb-uhci.c: interrupt, status 3,
but the frames were different, there were 340 lines. I have a USB printer also on this computer (a HP DJ861C which works with linux). I can't tell heads nor tails what the output of this command is telling me. Thanks for the advice Kriss. If anyone could help me out, I'd really appreciate it

[Dolda2000]

Hve you tried just /dev/sda? I wouldn't think that the camera has a partition table.

[Primary Canary]

I tried mounting /dev/sda like this as root

mount /dev/sda /mnt/camera

but I get an invalid block device error

My Phillips CD-RW is showing up as a scsi device under host scsi0

I'm not very familar with the naming scheme for partions and drives with linux. I tried mounting /dev/sdb, /dev/sdc, etc but all with no luck. Does anyone have any other ideas...or is it not possible to mount my USB Mass Storage device under linux? Thanks to all that have given their time and patience

[Dolda2000]

I went through a little trouble, too, when trying to get my keyring USB memory working with my Linux laptop, but it turned out to be possible. Have you checked so that sd_mod is loaded?