Server setup with two network cards

[whych]

I have a firewall which has 2 internal network addresses and cards - one for normal traffic and the other for the dmz.
I want to run a server with 2 network cards connected to the 2 different networks. How do I split the cards so they have separate nameservers and networks?
ie
card 1: 192.168.1.xxx for secure traffic
Card 2: 192.168.2.xxx for external web access

Card 2 must not route or foward to 192.168.1.xxx network.

[Lazydog]

Use your network configuration program to configure both interfaces.
Normally forwarding is turned off so you should have to worry about that.
As for 192.168.1.* not being routed to 192.168.2.* if someone is able to log onto the server then they could always ssh/telnet into 192.168.2.* unless you have it setup not to with the firewall.

[whych]

Thanks for that. What threw me at first was that in suse I had to first assign the card an ip address and save it and then go back to enter its routing info.
telnet/ssh aren't forwarded by the firewall server, only mail and web services.