... after using
Code:
modprobe at76c503
I recently founded that ArkLinux has the Atmel driver already installed, and it just needed to be loaded into a module. However, I need to configure my WUSB11 v2.6 Adapter. I know that I have "iwconfig" on my system, but it doesn't show "wlan0". Instead it shows:

Code:
lo     : Network Interface
sit0   : Network Interface
I need "wlan0" in order to configure my adapter.
Do you know how I can get "wlan0" to show up with "iwconfig"?

Also, once I get to that point, I need to figure out how to configure it using Konsole. Or, is it possible to configure it within KDE?