broadcom wlan card problem
I'm having trouble with a Broadcom BCM4306 wireless PCI card. I installed ndiswrapper and followed the instructions at http://ndiswrapper.sourceforge.net/m...p/Installation
ndiswrapper tells me I have the correct driver (the frontend ndisgtk also tells me so). The ndiswrapper module also appears to load correctly. But when I run iwconfig, I get:
iwlist also doesn't work. When I try to bring the interface eth2 up with ifconfig, I get this error:
eth2 IEEE 802.11b/g ESSID:"NETGEAR" Nickname:"Broadcom 4306"
Mode:Managed Access Point: Invalid Bit Rate=1 Mb/s
RTS thr:off Fragment thr:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
...which is the same error I get when I run /etc/init.d/networking restart
SIOCSIFFLAGS: Permission denied
I know the card works because it installs fine on a Windows box. I'm not sure what the deal is, and I've been working at this for a few hours now. Any ideas?