No scan results for iwlist with Marvell libertas 8686 WLAN-BT combo module on OMAP3
I am in the process of enabling WLAN for a target board. It has a WLAN Bluetooth (WLAN-BT) combo module SP-W8ME-A from MuRata which has a Marvell WLAN (88W8686) + CSR Bluetooth chipset.
The target runs on OMAP3 with WLAN brought up using the following setup,
Driver: Marvell libertas 8686 WLAN Driver
Firmware Version: fw 9.70.3p14
Linux Kernel Version: 184.108.40.206
With the above setup I am able to:
1) insmod libertas driver.
2) Load the firmware successfully (by the driver).
3) 'iwconfig' command shows me the following:
eth1 IEEE 802.11b/g ESSID:""
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
Bit Rate:0 kb/s Tx-Power=18 dBm
Retry limit:8 RTS thr=2347 B Fragment thr=2346 B
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
4) 'ifconfig' shows me that the interface is setup fine too.
Now I want to scan for networks, here I get into trouble.
5) 'iwlist' eth1 scan tells me 'No scan results'
I have setup test access points, so I am sure of getting at least one result.
I have tried scanning in both Managed and AdHoc mode and also on different channels.
My target always gives me a login shell with root access by default.
(So sudo is not required for iwlist as expected by some systems.)
The following are my concerns/queries:
a) What might be the possible cause of getting no results?
b) Is it that the libertas driver will not work for WLAN-BT modules?
(Scan works fine on other WLAN (8686) module without Bluetooth, so wireless tools seems to work fine.)
c) Can Bluetooth co-existence cause any problem?
Please help me fix this issue. (Post queries if you require any further clarification on the setup)
Thanks in Advance