When I select SATA in BIOS , my installation get HUNG at :

1) ide-cd : cmd 0*28 timeout
2) hda : DMA timeout
3) hda : statuis timeout : status= 0xd0
4) ide : failed opcode was : unknown
5) hda : drive not ready timeout
6) hda : ATAPI reset complete

When I select AHCI in BIOS , my installation get HUNG at :

1) ata6 : SATA Link Up 3.0 gbps
2) ata6 : ata-7 : st32503244 , 3.aaa,MAX udma/133
3) ATA6 : configured for UDMA/133
4) Vendor : ATA Type ; Direct Access
5) ANSI SCSI Revision : 05
6) SCSI device sda : 32503244 512 byte hdwr sector ( 250059 MB)
7) write protect is off
mode sense : 00 3a 00
SCSI : device sda dma cache : write back
9) sda : sd1 sd2 sd3
Attached SCSI disk drive
10) hda : DMA timeout
11) hda : statuis timeout : status= 0xd0
12) ide : failed opcode was : unknown
13) hda : drive not ready timeout
14) hda : ATAPI reset complete

What to do ?


My HDD is a 250 GB and Sata.

Awaiting for some feedback ...