Set up swap drive after install?
Can it be done?
Apparently I neglected to do so during installation.
Can I do it without installing it again, it is painfully slow without it :(
I'm running on an 8 yr old thinkpad with 192mb of ram! :(
If it can be done, can someone walk me through it?
Total newbie here!
I have an 10gb drive with 2 equal partitions, puppy is on the first partition and mepis is on the second, grub is installed to the mbr and loads both.
I would use puppy it was pretty good on my laptop but while it was a tad faster than windows it was a little too buggy for my liking so here I am with mepis.