After update my Vaio PCG-K33 won't connect to wireless anymore
Have updated to the .38 kernel because i was having the following problem. This is a Sony Vaio laptop. When i leave the front side wireless switch on and boot the compu eventually the mouse will not move anymore and i have to hard reboot. If i turn off the front side wireless switch, the computer finishes booting alright but then when i turn on the front side switch again, the led will no longer go to green and wireless is not recognized.
i once was able to boot into Safe Mode and started setting up wireless through MCC until i hit Connect -- upon which the compu froze again.
PCC says this is a Atheros AR5001x+ Wireless network adapter using the ath5k Module.
i have also tried to use the .iso to boot up. It boots and when i try to configure Wireless and hit Connect again, i get the same behavior - it freezes.
00:00.0 Host bridge: ATI Technologies Inc RS200/RS200M AGP Bridge [IGP 340M] (rev 02)
00:01.0 PCI bridge: ATI Technologies Inc PCI Bridge [IGP 340M]
00:03.0 Modem: ALi Corporation M5457 AC'97 Modem Controller
00:04.0 Multimedia audio controller: ALi Corporation M5451 PCI AC-Link Controller Audio Device (rev 02)
00:06.0 Bridge: ALi Corporation M7101 Power Management Controller [PMU]
00:07.0 ISA bridge: ALi Corporation M1533/M1535/M1543 PCI to ISA Bridge [Aladdin IV/V/V+]
00:09.0 Ethernet controller: Atheros Communications Inc. Atheros AR5001X+ Wireless Network Adapter (rev 01)
00:0a.0 CardBus bridge: Texas Instruments PCI7420 CardBus Controller
00:0a.2 FireWire (IEEE 1394): Texas Instruments PCI7x20 1394a-2000 OHCI Two-Port PHY/Link-Layer Controller
00:0a.3 Mass storage controller: Texas Instruments PCI7420/7620 Combo CardBus, 1394a-2000 OHCI and SD/MS-Pro Controller
00:0c.0 USB Controller: NEC Corporation USB (rev 43)
00:0c.1 USB Controller: NEC Corporation USB (rev 43)
00:0c.2 USB Controller: NEC Corporation USB 2.0 (rev 04)
00:0f.0 IDE interface: ALi Corporation M5229 IDE (rev c4)
00:12.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
01:05.0 VGA compatible controller: ATI Technologies Inc Radeon IGP 330M/340M/350M
[root@localhost hector9]# iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wlan0 IEEE 802.11bg ESSID:"INFINITUM3493"
Mode:Managed Access Point: Not-Associated Tx-Power=off
Retry long limit:7 RTS thr:off Fragment thr:off
Any ideas as to what's up? Is there a step-by-step i can use to troubleshoot this?
Have a great evening! :)