Find the answer to your Linux question:
Results 1 to 3 of 3
hi, i installed RHEL 6 as virtual host on one of the blades on HP enclosure. i set up network on eth0 and started it but i can not even ...
Enjoy an ad free experience by logging in. Not a member yet? Register.
  1. #1
    Just Joined!
    Join Date
    Feb 2011
    Posts
    1

    network issue on RHEL 6 virtual host insllation


    hi,
    i installed RHEL 6 as virtual host on one of the blades on HP enclosure. i set up network on eth0 and started it but i can not even ping gateway from within this installation. i logged in as root. i set up everything such as IP, netmask, gateway, nameserver etc. anyone has any clue ?

    thanks

  2. #2
    Linux Guru Lazydog's Avatar
    Join Date
    Jun 2004
    Location
    The Keystone State
    Posts
    2,677
    How was the network setup on the VM?
    As a Virtual Network or as a Shared Network?
    Is the Blade interface setup as a bridge?

    Regards
    Robert

    Linux
    The adventure of a life time.

    Linux User #296285
    Get Counted

  3. #3
    Just Joined!
    Join Date
    Jul 2008
    Posts
    17
    Does it only have a single NIC? If you have double NICs you might want to check if reverse path filtering is what causing you the trouble. If you have more than one nic during install, I would recommend to disconnect the other one and test again.

    Thanks,
    Erick

  4. $spacer_open
    $spacer_close

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •