Find the answer to your Linux question:
Results 1 to 3 of 3
Enjoy an ad free experience by logging in. Not a member yet? Register.
  1. #1

    Setting Bonding Eth on RHEL6.2

    Hello Linux Masters,
    I have case about Redhat / CentOS Bonding / teaming ethernet, on CentOS 6.2
    Been done this bonding before, on CentOS 5, it was so simple with web tutorial. But not in CentOS 6.2 since the modprobe.conf has been deprecated on this version.

    After doing some research, i found this site that teach me to set this up
    And success to create bonding, but after i did the #modprobe bonding
    i saw the result still not UP
    this is the result of /proc/net/bonding/bond0
    Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009)

    Bonding Mode: adaptive load balancing
    Primary Slave: None
    Currently Active Slave: None
    MII Status: down
    MII Polling Interval (ms): 100
    Up Delay (ms): 0
    Down Delay (ms): 0
    Actualy the eth bond0 is running but when i unplug one of the eth, the failover not working.
    Anyone know the solution?

    In Advance

  2. #2

    Follow the tutorial here:

    I hope this helps.

  3. #3
    Hello ifechi,

    Many thanks for your help.
    That link you gave me and this note part helping me somuch..
    Note: Set the NM_CONTROLLED="no" on all configurations otherwise the bonding interface will not come up. The documentation from Redhat fails to mention this.
    Thanks you

  4. $spacer_open

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts