I just built my new workstation based on the K8N-DL motherboard (nforce4 Pro chipset). I want to set up dual boot with Windows XP and FC3-64bit. Windows install/set-up took 30 mins but FC3 gives several error messages just after grub boots up the kernel.

PCI: Cannot allocate resource region 0 of device 0000:02:00.0
PCI: Cannot allocate resource region 3 of device 0000:04:00.0
Failed to allocate mem resource #3:1000000@fc000000 for 0000:04:00.0

After getting to the X init stage a distorted X windows screen (the welcome screen?) appears and the machine halts.
I edited /etc/inittab and booted in runlevel 3 wich was successful but I have no idea what to do to get X running properly.

Anyone got any ideas?

Steven

This is my machine spec...

ASUS K8N-DL M/B (Nforce4 Pro chipset)
nVidia SATA (non-RAID), onboard LAN and onboard audio all enabled
2 AMD Opteron 250 CPU's
4 512MB OCZ ECC/REG PC3200 DDR in dual channel mode
2 Maxtor Diamondmax 10 SATA 250GB HDD with NCQ and 16MB cache
Both drives attached to the nVidia SATA M/B connectors
Non-RAID set-up, windows on sda and linux on sdb
Alaska PowerPax 460W EPS12V PSU
Netgear WG311GT PCI wireless network card (to be ath1 once configured)
MSI NX6600GT PCI-express Graphics card


Update to this post:
reading the Xorg.0.log file reveals the following warning and error messages...

line 28...
(WW) Open APM failed (/dev/apm_bios) (No such file or directory)

lines 429 onwards...
(WW) ****INVALID MEM ALLOCATION**** b: 0xd0000004c9000000 e: 0xd0000004cfffffff correcting
(II) window:
[0] -1 0 0xc8000000 - 0xd0ffffff (0x90000000) MX[B]
(II) resSize:
(II) window fixed:
[0] -1 0 0xc8000000 - 0xd0ffffff (0x90000000_ MX[B]
(EE) sparse io range (base: 0x2a95c7d406 mask: 0xdd25c0)doesn't satisfy (case & mask = mask)
(WW) ****INVALID MEM ALLOCATION**** b: 0xd0000000 e: 0xd00fffff correcting
(II) window:
[0] -1 0 0xf8000000 - 0xfc0fffff (ox41000000) MX[B]
(II) resSize:
(II) window fixed:
[0] -1 9 0xf8000000 - 0xfc0fffff (0x41000000_ MX[B]
(EE) sparse io range (base: 0x2a95c7d406 mask: 0xdb8ca0)doesn't satisfy (base & mask = mask)

lines 498 and 1941
(WW) VESA(0): Bad V_BIOS checksum

I have "successfully" installed the nvidia driver but I only get a blank screen upon entering startx.