Find the answer to your Linux question:
Page 4 of 4 FirstFirst 1 2 3 4
Results 31 to 32 of 32
So far as I understand it, if I had the hard drive jumpered as Slave, but connected by itself on the IDE channel, then the machine wouldn't even be able ...
Enjoy an ad free experience by logging in. Not a member yet? Register.
  1. 10-26-2005 #31
    NomadOfNorad
    NomadOfNorad is offline
    Just Joined!
    Join Date
    Oct 2005
    Location
    Jacksonville, Florida, USA, Earth, Sol System, Milky Way galaxy...
    Posts
    18
    So far as I understand it, if I had the hard drive jumpered as Slave, but connected by itself on the IDE channel, then the machine wouldn't even be able to read the drive. So far as I recall, though, I either have it jumpered for Master or for Cable-select, and that I had double-checked at the time to make sure it was set that way (that is, that I hadn't set it to Slave). In any event, the BIOS screen shows it as the primary drive, and shows the secondary drive as empty (i.e. no drive present). I don't think that result would likely happen if I'd jumpered the drive to Slave.
    Reply With Quote Reply With Quote
  2. 10-27-2005 #32
    NomadOfNorad
    NomadOfNorad is offline
    Just Joined!
    Join Date
    Oct 2005
    Location
    Jacksonville, Florida, USA, Earth, Sol System, Milky Way galaxy...
    Posts
    18

    I give up...

    Okay, I've finally given up on using that machine, and have successfully installed SLAMPP onto a different machine...

    I am going to figure out some other thing to do with that machine, probably put Windoze on it.
    Reply With Quote Reply With Quote
Page 4 of 4 FirstFirst 1 2 3 4
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules