Sound blaster digital audio output

i'm a noob to linux so take it easy on me :) ... i used redhat for a few months and found it sucked for gaming
a buddy of mine has used slack for a few years and converted me to it ... i must say i'm very impressed
i've heard where people say slack isn't as user friendly as other distros but that's BS


enough rambling ......


i'm running slackware 10 ... fresh default install
soundblaster live value card w/ digital surround speakers
the card is recognized and works with my headset but i can't figure out how to enable digital audio output
i've done the following with no luck
alsaconfig
alsamixer ... unmuted and turned up volume for everything

i spent a few hours digging through forums last night and couldn't find an answer that worked

if anyone could shed some light my way i'd be greatful

thanks in advance

30 peeps ....noone with a soundblaster card huh ?

I've got the same issue just installed Manddrake 10.1 and I got no sound out of my digital speakers... if someone could give a link to some instructions that would be great.

Try doing one of the following:

- pico /etc/hotplug/blacklist - And Comment (# sign) the emu10k1 line.

or/and
- pico /etc/rc.d/rc.modules - And uncomment the /sbin/modprobe emu10k1

Hope it helps.

I got my Audigy working that way.

GL m8.

I don't see either of those lines in either of the files...
This is what it says in the Configure Your Computer Control Center... I ran the wizard and picked the audigy driver but it still shows its using the snd-emu10k1 thanks for any help.
To recap I get sound through the headphones but when i use alsamixer or kmix to Enable/Disable the digital output I get nothing then when i disable digital it works again in my headphones so it must be a driver issue correct? Also my motherboard has an onboard sound card that I don't use but could that possibly be causeing conflicts with the digital output? Thanks again for any advice.

Identification
Vendor: ?Creative Labs

Description: ?EMU10K2 Audigy Audio Processor

Media class: ?MULTIMEDIA_AUDIO

Connection
Bus: ?PCI

Bus PCI #: ?0

PCI device #: ?10

PCI function #: ?0

Vendor ID: ?4354

Device ID: ?4

Sub vendor ID: ?4354

Sub device ID: ?81

Driver
Module: ?snd-emu10k1

Alternative drivers: ?audigy, emu10k1

For cryin out loud... well I got it... IEC985 Optical Raw under Kmix was checked along with Digital Out... well I accidently unchecked it while I had the Digital Checked and wouldn't ya know BLAM it was comin out my speakers... thanks for tryin to help a noob though much appriciated.