Just installed 10.3, but no sound ?

[texanmutt]

I have have been using Linux for firewalls and certain servers, but i just now decided to take the plunge and install it on my laptop (although it is dual boot with Win XP). So being that I have been spoiled by WebGUI's and Webmin for years I cannot seem to make the sound work. My laptop is an Acer 3050. The sound configuration under Yast says that I have a SB 450 HDA audio card. This is what I get from an lspci-

# lspci
00:00.0 Host bridge: ATI Technologies Inc RS480 Host Bridge (rev 10)
00:01.0 PCI bridge: ATI Technologies Inc RS480 PCI Bridge
00:04.0 PCI bridge: ATI Technologies Inc RS480 PCI Bridge
00:05.0 PCI bridge: ATI Technologies Inc RS480 PCI Bridge
00:06.0 PCI bridge: ATI Technologies Inc RS480 PCI Bridge
00:07.0 PCI bridge: ATI Technologies Inc RS480 PCI Bridge
00:12.0 IDE interface: ATI Technologies Inc 4379 Serial ATA Controller (rev 80)
00:13.0 USB Controller: ATI Technologies Inc IXP SB400 USB Host Controller (rev 80)
00:13.1 USB Controller: ATI Technologies Inc IXP SB400 USB Host Controller (rev 80)
00:13.2 USB Controller: ATI Technologies Inc IXP SB400 USB2 Host Controller (rev 80)
00:14.0 SMBus: ATI Technologies Inc IXP SB400 SMBus Controller (rev 83)
00:14.1 IDE interface: ATI Technologies Inc Standard Dual Channel PCI IDE Controller (rev 80)
00:14.2 Audio device: ATI Technologies Inc SB450 HDA Audio (rev 01)
00:14.3 ISA bridge: ATI Technologies Inc IXP SB400 PCI-ISA Bridge (rev 80)
00:14.4 PCI bridge: ATI Technologies Inc IXP SB400 PCI-PCI Bridge (rev 80)
00:18.0 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] HyperTransport Technology Configuration
00:18.1 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Address Map
00:18.2 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] DRAM Controller
00:18.3 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Miscellaneous Control
01:05.0 VGA compatible controller: ATI Technologies Inc RS485 [Radeon Xpress 1100 IGP]
08:01.0 CardBus bridge: ENE Technology Inc CB-712/4 Cardbus Controller (rev 10)
08:01.1 FLASH memory: ENE Technology Inc ENE PCI Memory Stick Card Reader Controller (rev 01)
08:01.2 Generic system peripheral [Class 0805]: ENE Technology Inc ENE PCI Secure Digital Card Reader Controller (rev 01)
08:01.3 FLASH memory: ENE Technology Inc FLASH memory: ENE Technology Inc: (rev 01)
08:01.4 FLASH memory: ENE Technology Inc SD/MMC Card Reader Controller (rev 01)
08:02.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)

Is there any other commands I should run ?

[texanmutt]

Cancel that I fixed it by installing alsa.