I am appreciate that if anyone would tell me how to setup the USB modem in SUSE enterprise 10? As I know e.g for the COM will use ttyS0 but usb should ttyUSB0 or others. But in /var/log/messages only show as below. Didn't show ttyUSB0 or others. Please advise where can I found it and set it ! If no, How can I set in inittab ?


# modem getty

mo:235:respawn:/usr/sbin/mgetty –s 38400 /dev/modem


Jul 26 08:08:55 demo1 kernel: usb 1-4: new high speed USB device using ehci_hcd and address 8
Jul 26 08:08:55 demo1 kernel: usb 1-4: new device found, idVendor=047e, idProduct=2892
Jul 26 08:08:55 demo1 kernel: usb 1-4: new device strings: Mfr=1, Product=2, SerialNumber=0
Jul 26 08:08:55 demo1 kernel: usb 1-4: Product: Agere USB2.0 V.92 SoftModem
Jul 26 08:08:55 demo1 kernel: usb 1-4: Manufacturer: Agere Systems
Jul 26 08:08:55 demo1 kernel: usb 1-4: configuration #2 chosen from 1 choice





03: USB 00.0: 0000 Unclassified device

[Created at usb.123]

UDI: /org/freedesktop/Hal/devices/usb_device_47e_2892_noserial_if0

Unique ID: 1Yic.Yt+jriS6j2B

Parent ID: k4bc.eTsZyIgHxO4

SysFS ID: /devices/pci0000:00/0000:00:1d.7/usb1/1-1/1-1:2.0

SysFS BusID: 1-1:2.0

Hardware Class: unknown

Model: "Agere (Lucent) Agere USB2.0 V.92 SoftModem"

Hotplug: USB

Vendor: usb 0x047e "Agere (Lucent)"

Device: usb 0x2892 "Agere USB2.0 V.92 SoftModem"

Revision: "2.00"

Speed: 480 Mbps

Module Alias: "usb:v047Ep2892d0200dcFFdsc00dp00icFFisc00ip00 "

Config Status: cfg=no, avail=yes, need=no, active=unknown

Attached to: #2 (Hub)



Your help will be very very appreciated!



Many Thanks