I just bought us robotics 9107 modem/router. It gets connected to the internet, I can't!!! What is missing in my settings?
Here's some additional information:
19:29:46 ~-3$/sbin/ifconfig
eth0 Link encap:Ethernet HWaddr 00:01:02:0C:5D:34
inet addr:192.168.1.2 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::201:2ff:fe0c:5d34/64 Scope:Link
UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2 errors:0 dropped:0 overruns:0 frame:0
TX packets:17 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:632 (632.0 b) TX bytes:3094 (3.0 Kb)
Interrupt:11 Base address:0xec00

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:106 errors:0 dropped:0 overruns:0 frame:0
TX packets:106 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:7954 (7.7 Kb) TX bytes:7954 (7.7 Kb)

19:29:53 ~-4$/sbin/route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0 eth0
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo
0.0.0.0 192.168.1.1 0.0.0.0 UG 0 0 0 eth0

HEEEELLLPP!!!!
Yorgo