Find the answer to your Linux question:
Results 1 to 3 of 3
on reaching the last step HARDWARE CONFIGURATION while installing SUSE 10.1.. my screen suddenly goes BLANK and then there is no response, infact the monitor's (COMPAQ MV 520) light turns ...
  1. 01-28-2007 #1
    dr_smit
    dr_smit is offline
    Linux Newbie dr_smit's Avatar
    Join Date
    Dec 2006
    Location
    Raipur
    Posts
    171

    Screen goes blank...

    on reaching the last step HARDWARE CONFIGURATION while installing SUSE 10.1.. my screen suddenly goes BLANK and then there is no response, infact the monitor's (COMPAQ MV 520) light turns from GREEN to YELLOW indicating a no communication..

    On pressing restart and rebooting into Unconfigured Suse.. I can start YAST and when I try to configure GRAPHICS CARD & MONITOR.. It doesnt open..
    while I can open others like PRINTERS etc to configure..

    The trouble is that after a few minutes the monitor goes BLANK & doesnt respond


    Please help...
    Reply With Quote Reply With Quote
  2. 01-28-2007 #2
    dr_smit
    dr_smit is offline
    Linux Newbie dr_smit's Avatar
    Join Date
    Dec 2006
    Location
    Raipur
    Posts
    171

    Should I try what post # 81112 says about SAX2

    http://www.linuxforums.org/forum/sus...-10-2-a-1.html
    Reply With Quote Reply With Quote
  3. 01-29-2007 #3
    dr_smit
    dr_smit is offline
    Linux Newbie dr_smit's Avatar
    Join Date
    Dec 2006
    Location
    Raipur
    Posts
    171

    the link works

    this is to any one with monitor problem
    try as suggested in the above link
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

...