Results 1 to 3 of 3
Trying to install 10.2 in the text mode and and while the system is going through the hardware configuration, it completes the monitor/graphics card and the shows "Printer" "Analyzing your ...
- 02-06-2007 #1Just Joined!
- Join Date
- Jan 2007
- Location
- British Columbia
- Posts
- 15
Configuration Hangs at the Printer
Trying to install 10.2 in the text mode and and while the system is going through the hardware configuration, it completes the monitor/graphics card and the shows "Printer" "Analyzing your system" and hangs. It has been analyzing for 10 hours. No printer attached to the computer.
Any suggestions?
- 02-06-2007 #2Linux Engineer
- Join Date
- Feb 2005
- Location
- California
- Posts
- 803
Perhaps it's actually hanging on your graphics. I've not tried the text install but I have had lockups when running yast2 (which is the text mode of yast).
Are you using text install because you have a problem running in graphic mode? If not, why not give it a try in graphic mode.
- 02-06-2007 #3Just Joined!
- Join Date
- Jan 2007
- Location
- British Columbia
- Posts
- 15
Yes I was using the text mode. The program would not install in the GUI mode. I had the program installed and had some very frustrating problems trying to get my WUSB54G to work, and installed some packages I could not get un-installed, so I decide to re-install the complete program. Never had this problem the first time?
Reply With Quote 
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts