Results 1 to 5 of 5
I just want to say that I had suse 10.1 in that partition before and I had no such problem.Additionally,the install interface loads only in the acpi=off mode and only ...
- 03-06-2007 #1Just Joined!
- Join Date
- Feb 2007
- Posts
- 5
Installation is stopped because partitioner(suse 10.2) detects no hard disk.
I just want to say that I had suse 10.1 in that partition before and I had no such problem.Additionally,the install interface loads only in the acpi=off mode and only after I disconnect all my usb devices.Please help me guys...My nerves!!!!
Thank you in advance
- 03-06-2007 #2Linux Newbie
- Join Date
- May 2006
- Location
- Kansas
- Posts
- 187
When you boot your computer, go into your bios and make sure that your harddrive is being recognized. If that doesn't see it, Suse definitely won't either.
- 03-06-2007 #3Just Joined!
- Join Date
- Feb 2007
- Posts
- 5
It is recognized.Everything seems ok until I try to install.Please help me...I can't stand this situation.Any more ideas?
- 03-06-2007 #4Linux Newbie
- Join Date
- May 2006
- Location
- Kansas
- Posts
- 187
Is the harddrive the only device connected to the IDE cable inside your computer? If not, unplug whatever else is on it and plug ONLY the CD/DVD drive in the other IDE cable and then try again. It sounds like something is probably conflicting with your harddrive.
If that doesn't work, switch the cables on the harddrive and CD/DVD drive and try again. Perhaps a bad IDE cable?
- 03-07-2007 #5Just Joined!
- Join Date
- Feb 2007
- Posts
- 5
My hard disc is not connected with a ide cable like the dvd-rom but with a different one...My disc is sata...does it mean something to you?
Reply With Quote 
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts