El Muelio

I have followed several thingies, but the problem is, I need to install eagle-usb, which installs fine, but someone else says I need to run:

apt-get install eagle-usb-modules-source

and

apt-get install eagle-adsl-modules-src

Apparently these are not on my install CD.

I am using 7.10, or the Gutsy Gibbon version of Ubuntu if that helps.


I have followed this:



1. System>Administration>Synaptic Packet Manager
2. Scroll down left hand menu. Click on Networking.
3. In right hand box, mark 'eagle-usb-data' and 'eagle-usb-utils' for installation.
4. Stick the Ubuntu installation CD in the drive.
5. Click Apply
6. The system should then install these two packages from the CD.
6.5 Plug in your modem.
7. Go to Applications>System Tools>Root Terminal. (Don't do what I did the first four times I tried this and go to Applications>System Tools>Terminal. You need to be in root to make it work.)
8. At the prompt type in 'eagleconfig'. This will give you a list of options for different ISPs. You'll see Tiscali at the bottom as 'UK01'
9. Type in 'UK01'
10. At the prompt, type in your ISP username
11. At the prompt, type in your ISP password
12. At the prompt about encryption, say 'no'
13. At the prompt about startup on boot, say 'no'
14. You should then get a message saying that configuration was successful.
15. Type 'startadsl'
16. Go to System>Administration>Networking
17. Double click on 'Ethernet connection eth01'
18. Tick the 'This device is configured' box'
19. Change the Connection Settings Configuration drop down from 'Static IP Address' to 'DHCP'
20. Click 'OK'
21. This takes you back to the first dialogue box.
22. Make sure that 'Ethernet connection eth01' is highlighted and then click on 'Activate'

When I get to 14, it doesn't say yes well done, it says:

/usr/sbin/eagle config: illegal operation

If I said yes to the the 2 options just before, if I say no to bothit says:

/usr/sbin/eagle config: illegal option


How do I continue on to 15+? Any Ideas?

Also, I am not running an Ehthernet connection, I am running a USB connection, does this change the instructions?