Find the answer to your Linux question:
Results 1 to 2 of 2

Thread: Fedora Wifi

Enjoy an ad free experience by logging in. Not a member yet? Register.
  1. #1

    Fedora Wifi

    I Just reinstalled Fedora (6.93) - it seesmy card - but i can not make it active?
    00:09.0 Network controller: Broadcom Corporation BCM4306 802.11b/g Wireless LAN Controller (rev 03)
    eth1      IEEE 802.11b/g  ESSID:""  Nickname:"bread"
              Mode:Master  Frequency=2.417 GHz  Access Point: Invalid
              Bit Rate=1 Mb/s
              RTS thr:off   Fragment thr:off
              Encryption key:off
              Link Quality=0/100  Signal level=-256 dBm  Noise level=-256 dBm
              Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
              Tx excessive retries:0  Invalid misc:0   Missed beacon:0
    When I try to make it active in the network device control via KDE:
    SIOCSIFFLAGS: No such file or directory
    Determining IP information for eth1... failed; no link present.  Check cable?
    Where do I start - this is the last thing for linux and I am up and running.

  2. #2
    Little Bump

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts