Hi everybody,

I'm trying to install a Linksys WUSB11 v2.6 on an IBM T22 running OpenSuse 10.2. This card used to work on the same machine when I had Suse 10.0 (or maybe 10.1 - I forget) without installing any drivers or anything on my part. I just learned to compile from source and downloaded and installed the latest ndiswrapper ver 1.47. I downloaded the latest driver from Linksys and then did the following:

nuw-T22:/home/nwebb/downloads # cd WUSB11v26_102003
nuw-T22:/home/nwebb/downloads/WUSB11v26_102003 # cd Drivers
nuw-T22:/home/nwebb/downloads/WUSB11v26_102003/Drivers # ndiswrapper -i NETUSB.INF
installing netusb ...
nuw-T22:/home/nwebb/downloads/WUSB11v26_102003/Drivers # ndiswrapper -l
netusb : driver installed

******NOTE: I plugged the card in at this point ********
nuw-T22:/home/nwebb/downloads/WUSB11v26_102003/Drivers # ndiswrapper -l
netusb : driver installed
device (077B:2219) present
nuw-T22:/home/nwebb/downloads/WUSB11v26_102003/Drivers # depmod -a
nuw-T22:/home/nwebb/downloads/WUSB11v26_102003/Drivers # modprobe ndiswrapper
Segmentation fault
nuw-T22:/home/nwebb/downloads/WUSB11v26_102003/Drivers # iwconfig
lo no wireless extensions.

irda0 no wireless extensions.

eth0 no wireless extensions.

sit0 no wireless extensions.

I've done my best to try to follow all the instructions on the ndiswrapper site, but really don't know where to go from here. Any help is much appreciated.

Thanks in advance