Intel 2200BG wireless card not working
Hi, this is my first post on these forums :P
Anyway, I JUST downloaded ubuntu and for some reason and my intel 2200bg wireless card has been working fine. But I tried hibernating my laptop a couple days ago, and it went all screwy (I can only assume my laptop does not supposed hibernation mode?) and I had to go into the BIOS and reset everything to its default settings. After that, my wireless card stopped working properly, although the package is supposed to be installed already in my version. I've scanned many other forums, and here is the information one would probably need:
lo no wireless extensions.
eth0 no wireless extensions.
eth1 radio off ESSID:""
Mode:Managed Channel:0 Access Point: Not-Associated
Bit Rate:0 kb/s Tx-Power=off Sensitivity=8/0
Retry limit:7 RTS thr:off Fragment thr:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
irda0 no wireless extensions.
SUDO LSHW -C NETWORK
kyrie@kyrie-laptop:~$ sudo lshw -C network
[sudo] password for kyrie:
description: Wireless interface
product: PRO/Wireless 2200BG Network Connection
vendor: Intel Corporation
physical id: 4
bus info: pci@0000:02:04.0
logical name: eth1
width: 32 bits
capabilities: pm bus_master cap_list ethernet physical wireless
configuration: broadcast=yes driver=ipw2200 driverversion=1.2.2kmprq firmware=ABG:220.127.116.11 (Mar 22 2005) latency=64 link=no maxlatency=24 mingnt=3 module=ipw2200 multicast=yes wireless=radio off
description: Ethernet interface
product: NetXtreme BCM5705M_2 Gigabit Ethernet
vendor: Broadcom Corporation
physical id: e
bus info: pci@0000:02:0e.0
logical name: eth0
width: 64 bits
capabilities: pm vpd msi bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt 1000bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=tg3 driverversion=3.86 duplex=full firmware=5705-v3.14 ip=192.168.1.102 latency=64 link=yes mingnt=64 module=tg3 multicast=yes port=twisted pair speed=100MB/s
I have an HP compaq nc8000, the default switch doesn't work in linux (i think it's fn+f2).
Note that I am a complete newbie to linux; please explain in detail what to do.